SmartHCF Mobile Modem Designer’s Guide
The EEPROM interface signals are:
• Serial Data Input (SROMIN); input
• Serial Data Output (SROMOUT); output
• Clock (SROMCLK); output
• Chip Select (SROMCS); output
LSD Interface (Through DIB)
The DIB interface signals are:
• Clock and Power Positive (PWRCLKP); output
• Clock and Power Negative (PWRCLKN); output
• Data Positive (DIB_DATAP); input/output
• Data Negative (DIB_DATAN); input/output
VC Interface (S Models)
The VC interface signals are:
• Modem Sleep (IASLEEP); output
• Master Clock (M_CLK); output
• Voice Serial Clock (V_SCLK); input
• Voice Serial Control (V_CTRL); output
• Voice Serial Frame Sync (V_STROBE); input
• Voice Serial Transmit Data (V_TXSIN); output
• Voice Serial Receive Data (V_RXOUT); input
Telephone Handset Interface (S Models)
The telephone handset interface signals are:
• Voice Relay Control (VOICE#); output
• Handset Pickup Detect (H_PICKUP); input
Call Progress Speaker Interface
The call progress speaker interface signal is:
• Digital speaker output (DSPKOUT); output
DSPKOUT is a square wave output in Data/Fax mode used for call progress or carrier monitoring. This output can be
optionally connected to a low-cost on-board speaker, e.g., a sounducer, or to an analog speaker circuit.
3.1.2 HSD Interface Signals, Pin Assignments, and Signal Definitions
The HSD (P9573) 100-pin TQFP hardware interface signals are shown by major interface in Figure 3-1, are shown by pin
number in Figure 3-2 and are listed by pin number in Table 3-1.
The HSD hardware interface signals are defined in Table 3-2.
3-2
Conexant
100475A
Conexant Proprietary Information